Versetta Stone Installation Tips

Efficient is defined as achieving the maximum productivity with minimum wasted effort or expense and with Versetta Stone, that is exactly what you get! Versetta Stone is a mortarless stone siding that looks like the real thing without all the time, energy, and mess. Its lightweight, fiber reinforced concrete replicates the look and feel of stone and the tongue and groove system make for easy installation without the hassle of mortar.

You can learn all about the Versetta Stone, its styles, colors, and details in our August Spotlight!

Versetta Stone Installation is easy and efficient, reduces installer fatigue, and can be installed by almost any siding contractor or carpenter. You can download the complete installation guide here.

Follow these simple tips for a successful installation.

Recommended Tools

• Hammer or pneumatic roofing nail gun
• Circular Saw
• Hand Grinder
• Level
• Chalkline / Tape Measure
• Tin Snips
• Brush
• Small Screwdriver
• Chop saw or wet saw with continuous diamond turbo blade

Recommeded Tools

 

Getting Started

• Designed for application over wood framing, spaced 16" on center.
• Use code-approved, nailable sheathing products with a minimum thickness of 7/16" for OSB or 1/2" for plywood.
• Install over Water Resistive Barrier (WRB) according to local building codes.
• Install Starter Strip perfectly level at your starting point.
• Lap WRB over starter strip nail flange.

 

Fastening Versetta Stone Panels

• Panels are installed from bottom to top and lapped in shingle fashion so the tongue seats completely in the groove.
• Stagger panels to avoid the alignment of vertical joints.
• Each panel requires a minimum of 4 fasteners when the length is greater than 18".
• Panels greater than 18" should have 2 of the 4 fasteners into framing.
• Use corrosion-resistant galvanized roofing nails.
• Or, use screws with 3/8" minimum head diameter and 1/8" shank with a length to penetrate the framing at least 1".

Fastening Panels

 

Cutting Panels

• Straight and angle cuts can be made with any of the cutting tools listed above.
• Cut panels with the tongue facing the fence.
• Trimming and staggered cuts are best made with a hand grinder utilizing a masonry blade.
• Holes can be made using a masonry hole saw, drill, or grinder with a masonry blade.

Cutting Panels

 

Installing Universal Corners

• Universal Corners must be cut into 2 pieces to create left and right.
• Cut random lengths to assist with creating a staggered appearance.
• Start at bottom of wall and position one half of a Universal Corner, nail flange up, cut edge away from corner, into starter strip.
• The standard Flat Panel side tongue will need to be removed in order for the Flat Panel to tightly seat against the Universal Corner.
• Fine tune the corner appearance with slight adjustments of both pieces until you get the best fit.

Universal Corners

 

Additional Versetta Stone Installation Guides and Information

Watch Install Video
Versetta Stone Flashing and Construction Details
Versetta Stone Application Over Continuous Application
Versetta Stone Continuous Insulation Concrete or Masonry Walls

Marsh Building Products